Wds mikrotik setup

Rule enables wireless interface and sets up appropriate configuration: band, frequency WDS peers all need to be on the same frequency , SSID, wds-mode static - WDS interfaces created manually in static mode.

First we create bridge interface on the router, then 'wlan1' and 'wds1' interface are added to the bridge. Let us consider wireless repeater configuration. First we need to establish communication to 'Main Gateway' router.

The rules are quite similar to 'Main Gateway' configuration rules. We need to enable wireless interface, than set appropriate wireless and WDS configuration don't forget about the same frequency channel and add interface to created bridge. Next, we should configure second wireless interface.

Rules are very similar to the previous one. IP address configuration is required for troubleshoot options. Repetear will work fine without IP address configuration. Finally, we need to configure AP1, AP2 client routers, which will provide connection to the Internet for the end-user. Add client interface to bridge Ethernet, wireless. I've tried multiple tutorials but I'm unable to get it working. Can anyone please suggest dead simple steps how to approach this problem?

I've enabled WDS - dynamic mesh on the 2ghz wlan and used the default bridge or a custom mesh-interface as the WDS bridge. What's actually the right interface to be used as the WDS bridge? And does this band then need to be dedicated only for the AP to AP communication?

Do I need to specify the frequency explicitly on both APs or can I leave in auto? Shall the frequency match or differ?

Thank you very much. Is it possible get some quotes for professional support? OK But don't be surprised The RB is set as your router with all the functions needed as if it was stand-alone. The hAP ac2 will be set up as a very simple switch network terminology, layer 2 domain switching, no higher layer functionality. Forget WDS, forget mesh