The lowest of the frequencies detected on the Channel 1 V and A inputs is displayed. This frequency is used as the fundamental for harmonic analysis. These are associated with only specific basic measurements. MENU Enter and exit the menu system. Clear erroneous menu data. See page 23 for a full description of the cards available for your analyzer.
For operating instructions, see the manual supplied with the interface card. Page 18 Range in M[2] and then enter the approximate maximum peak current or voltage that is expected. This can be measured by pressing the PEAK key. It is not necessary to remember the exact ranges of the PM, since they will be selected for you according to the following tables.
When using the inrush current mode on the PM, it is advisable to first set manual range as describe on page 12 to monitor the signal before the inrush mode is issued. Page 21 This mode may be used to average measurements over a long interval from 10 to seconds. This is ideal for most measurement applications. The display is 'blanked'. To view small signals, disable the blanking by selecting ' '. For best accuracy, however, bring the signals into the normal operating range of the analyzer.
Page 25 A measurement of the average input power is required to check the rating of the power supply. With the waveform above, the measurements are not stable, and the analyzer pauses while it auto-ranges in between readings.
Page 26 5. AT USB driver v2. Product Firmware. AT Firmware v1. AT Firmware v3. ATi Firmware v3. User Manuals. AT Manual v17 12 May ATi User Manual v8 18 Nov DC Manual v8 20 Sep AT Server Manual v1 for V3.
AT Editor Manual v1 for V3. This site uses cookies on your computer to help improve your experience. Please see the following for each PM product type.
Each section contains manuals, firmware and general information. How do I update firmware? What is the latest firmware? Instructions in link below. How do I Calibrate the unit?
The Calibration method is contained within the user manual - link below. Is the VPAS software still available? The VPAS software for data logging is no longer available for new sales. The last release was V 2. Is the IEC software still available? The IEC software is no longer available for new sales.
0コメント