Instructions Cut the Hole in the Ceiling. Run Wiring to the Ceiling Hole. Attach the Wire to the Recessed Light. Install the Light in the Ceiling Hole. Add the Recessed Light Trim. Add the Right Bulb. Wire the Circuit to the Service Panel. Drop ceilings may also be used to hide problems, such as structural damage. White to white, black to black throughout.
If you wire them in series, you will only get a dim glow based on the number of units you wire in. The main limitation to the number of recessed fixtures you can run at the same time is the rating of the circuit breaker that controls the circuit. Try to avoid creating any shadows. Then space your downlights evenly across the room for a balanced look. A general rule of thumb for spacing your downlights is to take the height of your ceiling and divide by 2. For example, if your ceiling is 8 feet high, then your downlights should be around 4 feet apart from each other.
The common rule is that 4-inch fixtures should generally be placed at least 4 feet apart and 6-inch fixtures about 6 feet apart. Yes, you need sic to hire a licensed electrican to install recessed lights in a ceiling. Yes, a person with good knowledge and experience in electrical work is able to preform the work. Instructions Open the Fixture and Test for Power. Remove the dome or shade on the ceiling light, then remove all light bulbs.
Remove the Fixture. Cut Out the Fixture Hole. You should space them out according to your ceiling height, any focal points that you want to add, and how bright you want your room's ambient light to be. For more detailed advice on how to layout your recessed lights, check out this article: How To Layout Recessed Lighting in 4 Easy Steps.
Drop ceilings are too delicate to support the weight of recessed lights on their own. Also, as your structure settles and shifts, the drop ceiling will move. Install extra wire supports over the tile to help hold the lights - one wire for each of the four corners of the tile. Using support bars or blocks with an additional frame that rests on the ceiling grid will work too. Make sure you can mount the light so it's flush with the face of the tile. T-grid mounting plates are available for canless LED downlight fixtures to help support the weight.
On each ceiling tile where you're adding a recessed light, trace the light's outline. Do this in the exact center of the tile, and double check that the opening is sized according to your light's installation instructions. Cut the first hole out using a keyhole saw or utility knife. Dust off any loose particles and set the panel back into its opening.
If you mistakenly cut a whole too large, don't worry, extended goof ring trims are available to mask any imperfections made in the ceiling while cutting. Take out one panel next to the panel you just cut. Place the light up over the cut panel and attach it to the supports.
Make sure it's positioned over the hole. If you're not familiar with how to wire your lights to power, it's best to hire an electrician. Most municipalities require a certified professional to connect the lights into your home's main electrical box and inspect the circuit. This can be very dangerous to do if you're not trained for it.
Install the light bulbs into the cans if necessary and snap the trim ring onto the housing. Turn on the lights, and voila! For more information, visit the recessed lighting page. Subscribe to our newsletter and be the first to know about exclusive offers!
0コメント